Entries 3
Page 1 of 1
the imprecision that is
…Design Space. Oh Cricut, another fail. I never thought it would be so difficult to place a .5”x2.5” piece of brass on a mat and engrave on it. I suppose it’s not. Unless you have no idea where t...
Preliminary engraving
Got my engraving tip yesterday and ran it on my previously failed attempt on the brass plate. It only did one letter before randomly stopping and Design Space saying “oops! It didn’t work!” (So h...
The struggle bus that is...
…Design Space. I switched gears last night to what I thought would be a much simpler project: engraving some text on five 2.5”x.5” inch .6mm thick brass plates (or aluminum if the brass proves to...
Book Description
This book exists since there seems to be a sore lack of information that’s helpful to a designer in the Cricut realm. I’ll put what I discover here, based on how things are going so far I might be venting here as well.
